Pioneer DVR-220 - Manual (Page 82)

The Initial Setup menu 12
82
En
Video In / Out settings
Input Colour System
• Default setting: Auto
On the default setting, the recorder automatically detects
whether the video signal from the built-in tuner or from
one of the external inputs is PAL, SECAM, 3.58 NTSC or
PAL–60. You may, however, occasionally need to set it
manually if the picture is not displayed properly.
1 Select ‘Input Colour System’, then ‘Next Screen’.
2 Use the CHANNEL +/– buttons or the INPUT
SELECT button to switch between the built-in tuner
and the external inputs.
3 Use the / (cursor left/right) buttons to
change the input colour system for the current input
or built-in tuner.
• The available settings depend on the Input Line
System setting (see Input Line System on page 78).
The table below shows the different options available.
AV1 Out
• Default setting: Video
You only need to make this setting if you connected this
recorder to your TV using the
AV1(RGB)-TV SCART AV
connector.
Important
• If you make a setting here that is incompatible with
your TV, the TV may not display any picture at all. If
this happens either switch everything off and
reconnect to the TV using either the supplied video
cable, or an S-video cable (see
Using the S-video
output on page 15 for more on this), or reset the
recorder (see Resetting the recorder on page 92 for
how to do this).
• Video – Compatible with all TVs, but lowest quality of
the three AV settings.
• S-Video – Almost the same quality as RGB, but can
give better results if you are using a long SCART
cable.
• RGB – If your TV is compatible, this setting gives the
best picture quality.
AV2/L1 In
• Default setting: Video
You only need to make this setting if you connected this
recorder to another component using the
AV2/AUTO
START REC (INPUT 1/DECODER) AV connector.
The AV2/AUTO START REC (INPUT 1/DECODER)
connector input can be set to one of the following
settings:
• Video – Sets the input signal type to composite
video.
• S-Video – Sets the input signal type to S-video.
• RGB – Sets the input signal type to RGB video.
Input Line System Built-in tuner External input
625 System Auto Auto
PAL PAL
SECAM SECAM
525 System n/a Auto
3.58 NTSC
PAL–60
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback Input Colour System
AV1 Out
AV2/L1 In
NTSC on PAL TV Next Screen
Initial Setup
Auto
Pr 5
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback Input Colour System
AV1 Out
AV2/L1 In
NTSC on PAL TV Video
S-Video
RGB
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback Input Colour System
AV1 Out
AV2/L1 In
NTSC on PAL TV Video
S-Video
RGB
Decoder
Initial Setup
DVR-04_UK.book 82 ページ ２００４年４月１１日 日曜日 午後５時２０分