Panasonic SX-KN7000 - Manual (Page 126)

SINGLE LOAD
You can specify which data to load from a disk
into a specific PANEL MEMORY, COMPOSER
(MEMORY),
SOUND MEMORY, EFFECT
MEMORY or SEQUENCER (when SONG SAVE
was executed) memory.
1. Use the PAGE buttons to access the PAGE
3/3 SINGLE LOAD display.
• The display looks similar to the following.
2. Use the MODE button to select the data you
wish to load.
3. Use the BANK/SINGLE button to select the
load increment. (except for SEQUENCER)
BANK:
Load one bank at a time.
SINGLE:
Load the smallest data increment.
4. Follow the appropriate procedure to load the
specified data.
• Specify the data source for FROM (left side),
and the data destination (this instrument’s
memory location) for TO.
• In the case of the COMPOSER, when you
press the ACCOMP DSP COPY OPTION but-
ton, you can specify which effects to load.
SMF LOAD
Load data which was saved in the “Standard MIDI
File” (SMF) format.
1. On the LOAD (PAGE 1/3) display, press the
SMF button.
• The display looks similar to the following.
• For disks which contain SMF files only, this
display appears automatically when LOAD is
selected on the DISK MENU display.
2. Use the buttons below the display to select
the filename you wish to load.
• If the number of files is 10 or more, you can
use the PREV and NEXT buttons to go back
or advance 10 files at a time.
• If you press the TECH button, the display
changes to the LOAD display for Technics
format.
• You can use the INFORMATION button to
switch the displayed data.
DISK: Disk name
SONG: Song name
3. Use the TO SONG button to select the number
to load to (this instrument’s SEQUENCER
song number).
• Songs to load are specified one at a time.
• The song name to load to is shown below the
TO SONG button.
4. Use the LOAD AS button to specify the load
method.
Select from the following.
GM/GM2
→ GM2:
Activate the GM2 initialized settings, and
load GM/GM2 data.
NX
→ NX:
Active the NX SOUND settings, and load
NX data.
GM/GM2 → NX:
Activate the NX SOUND initialized settings,
and load GM/GM2 data.
PREV. TEC → NX:
Activate the NX SOUND initialized settings,
and load SMF data that was saved in the
TECHNICS mode on a previous model.
(The volume balance and octave settings
may differ from the saved settings.)
• If you select the setting which is different from
that in which the song was stored, the sounds,
octaves, and arrangement of percussion in-
strument sounds, etc. will be different.
5. Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully
completed, “COMPLETED!” is shown on the
display.
• If you press the START/STOP button, play-
back of the loaded data begins.
• During the LOAD operation, data that cannot
be processed by this instrument is ignored.
Di
sk Dr
iv
e
Part VI Disk Drive
126
QQTG0671