Panasonic SX-KN7000 - Manual (Page 89)

4. Use the MEAS
∧
and
∨
buttons to select the
measure.
• This step is not necessary if you are recording
from measure 1 of a blank track.
5. Use the CURSOR < and > buttons to move
the cursor to the note position (dot) you are
going to store.
• Each dot represents one-eighth of a quarter-
note (a thirty-second note).
• When storing triplets, it may not be possible
to match the timing exactly with the 1/32-note
steps. However, if you select triplet-type notes
for the note length (LENGTH) in step 6 below,
the timing is automatically corrected.
6. Use the left LENGTH
∧
and
∨
buttons to
specify the note value. Select from
3,
,
3,
, 3, , 3, , , ,
× 2 to 4. (A 3 denotes a
triplet-type note.)
• For note values other than these, use the right
LENGTH buttons to specify the note value to
be added to that which you specified with the
left buttons.
Example: To record a dotted quarter-note ( . )
+
7. Use the PHRS
∧
and
∨
buttons to specify the
actual length of the produced sound for the
desired legato or staccato effect.
8. Specify the pitch and velocity of the note by
playing the keyboard.
• The dot on the display where the note is stored
changes to a * mark.
• When recording chords, you can store multiple
notes at one position.
• Any panel setting changes— for example
changes in the sound selection, button opera-
tion, wheel operation, etc.— are recorded at
the cursor position.
• When a wheel or dial is operated, the input
value is indicated on the display. Confirm that
this is the correct value and press the YES
button to record the value or the NO button to
cancel it.
REST:
To store a rest, after specifying the note
LENGTH, press the REST button.
• Positions at which nothing is stored are read
as rests.
ERS:
If you make a mistake, move the cursor to the
error, and after displaying the data you wish
to erase, press the ERS button.
BAL:
To specify the volume at the cursor position,
after pressing the BAL button, use the VALUE
buttons to set the volume (0 to 127).
9. Repeat steps 5 through 8 to continue storing
notes.
• To input data on another track, press the but-
ton for the desired track and repeat the pro-
cedure from step 2.
10. When you have finished recording, press the
PROGRAM MENUS button to turn it off.
Storing control data
Various control data can be stored at the cursor
position.
1. On the STEP RECORD: MELODY display,
press the CTL button.
2. Use the CTL
∧
and
∨
buttons to select the
control data you wish to insert.
• Select from PAN, KEY SHIFT (COARSE
TUNE), TUNING (FINE TUNE), BEND SENS.
3. Use the VALUE
∧
and
∨
buttons to adjust the
numerical value of the setting.
4. Press YES button.
TENU (tenuto): Sound is produced for 95%
of the note length.
NORM (normal): 80%
STAC (staccato): 50%
CUTT (cutting): 25%
Se
q
u
e
n
c
e
r
Part IV Sequencer
89
QQTG0671