Pinnacle Design Pinnacle Systems Media Stream Media Gateway 37T100105 - Manual (Page 24)

Chapter 3: Installation and Setup
24 MMG Installation, Setup, and Operations Guide
Note: This number may change depending on the number of clients connected to the PS100, and
the client’s bandwidth allocation. The total MAS bandwidth allocation (-lb on the MAS command
line) should be adjusted to compensate for the reserved bandwidth given to FileZilla.
Configure the MMG
The MMG needs the network information of the TCS server, the source host(s), and the
destination host(s). The IP addresses of these machines must be entered for MMG to function. To
configure MMG launch the MMG config tool by double clicking on the MMG Config icon on the
desktop. This launches the MMG configuration tool as shown in Figure 3-17.
Figure 3-17: Configuration Tool
There are two sections in the configuration tool, the TCS servers and the Hosts. The TCS section
contains only the IP addresses of the machines running the TCS applications. The Host section
contains the information of all of the source and destination machines.
To add a TCS server to MMG, edit the fields in the top group box labeled Edit Transfer Control
Servers:
1. Enter the IP address of the TCS server. The TCS server runs on the ConnectPlus gateway.
2. Enter a label for the TCS server corresponding to the IP address. The label can be the
hostname of the machine, or any unique label to identify the machine. This label appears in
the TCS dropdown list of the MMG application.