Pinnacle Design Pinnacle Systems Media Stream Media Gateway 37T100105 - Manual (Page 39)

Chapter 3: Installation and Setup
MMG Installation, Setup, and Operations Guide 39
Setup the Codec Preset 2 in the timeline
To setup a Codec Preset right click a empty space of the timeline and select Timeline properties...
from the drop-down menu (see Figure 3-34 on page 35).
In the Render/Fuse Codec Pres. dropdown list box, select the Codec Preset value you just created.
For this example we select the Preset 2: SD PS 422 IBBP.
Figure 3-41: Preset 2 Codec Settings
XSend a sequence with Standard 422 (s422)
1.
To XSend a sequence, right-click the sequence and select XSendTo. From the submenu that
appears, select XSendToMSS (see Figure 3-36 on page 36).
2. When the XSend to XSend To MSS dialog appears, leave settings as default and click OK
(see Figure 3-37 on page 37).
3. The IBP Settings dialog appears.Select the <MPEG-2 422P@ML> Reference Set. Change
the Bitrate mode to Constant (CBR). Drag Maximum Bit Rate slider to 50.00. Its ok to leave
the other settings as default. Click the checkbox to accept settings. Check the 4:2:2 box and
unchecked the Extended Resolution box. You can leave the other settings as default.
4. Click OK in the Fuse Sequence dialog that appears (see Figure 3-39 on page 38).
XSend a sequence with Extended 422 (e422)
1.
To XSend a sequence right-click the sequence you want to send, select the submenu
“XSendTo” and here the menu point “XSendToMSS”.
2. When the XSend to XSend To MSS dialog appears, leave settings as default and click OK.
3. The IBP Settings dialog appears.Select the <MPEG-2 422P@HL> Reference Set. Change the
Bitrate mode to Constant (CBR). Drag Maximum Bit Rate slider to 50.00. Its ok to leave the
other settings as default. Click the checkbox to accept settings. Check the 4:2:2 box and
unchecked the Extended Resolution box. You can leave the other settings as default.
4. Click OK in the Fuse Sequence dialog that appears.