Pioneer PureVision PDP 5040HD - Manual (Page 25)

07 Preparation
English
25
En
U/V mixer
• Be sure to connect the antenna or the Cable
Converter as shown above. Signal reception may
fail if not properly connected.
• Be sure that the Cable Converter output signal is
assigned to the ANTENNA/CABLE B input on the
Media Receiver.
• How to change channels when the Cable Converter
output signal is connected to the ANTENNA/CABLE
B input on the Media Receiver.
• Press ANT on the remote control unit to switch to
ANTENNA/CABLE B.
• You can view an image right after selecting the
output channel on the Cable Converter.
Switching between tuner A and B
To watch broadcasts via the two tuners, you can select
it by pressing ANT on the remote control unit.
• While watching a broadcast, press ANT to view the
image received from the other tuner.
• Pressing ANT while viewing in Dual Screen mode
(TV image and video image) with TV selected will
display the TV image of the other tuner.
• Pressing ANT while viewing Dual Screen with two TV
images displayed will not have any effect.
• Pressing ANT while viewing Dual Screen with two
video images displayed will switch the selected
screen to a TV image.
Media Receiver (rear) VHF antenna UHF antenna
Cable TV
I N
A ANTENNA/CABLE B
OUT
I N
OUT
Cable Converter
When making the above connections, first
remove the coaxial cable attached before
shipment.
Connecting a VHF/UHF antenna and Cable Converter
PDP5040HD-Eng (17-27) 7/24/03, 1:58 PM 25