Pioneer PureVision PDP 5040HD - Manual (Page 27)

07 Preparation
English
27
En
Power cord
Power cord
• Use only the power cord provided.
• Do not use a power supply voltage other than
that indicated as this may cause fire or electric
shock.
• For the Plasma Display System, a three-core
power cord with a ground terminal is used for
efficiency protection. Always connect the power
cord to a three-pronged outlet and make sure
that the cord is properly grounded. If you use a
power source converter plug, use an outlet with
a ground terminal and screw down the ground
line.
• Always turn off the power of the Plasma Display and
Media Receiver when connecting the power cords.
• Disconnect the power cord from the power outlet
when the Plasma Display System is not going to be
used for a long period of time.
I N
SERVICE ONLY
MONITOR OUT
DIGITAL OUT OPTICAL
INPUT 1 COMPONENT VIDEO
S400 DTV-ANTENNA IN
INPUT 3
VCR CONTROL
A ANTENNA/CABLE B
OUT
I N
I N
OUT
CONTROL OUT
S-VIDEO
S-VIDEO S-VIDEO R-AUDIO-L R-AUDIO-L Y
AC INLET
BLACK
WHITE SYSTEM CABLE
R-AUDIO-L R-AUDIO-L Y
CB/PB
CB/PB
CR/PR
CR/PR
VIDEO
VIDEO VIDEO
INPUT 2
(TS)
AC INLET
Connecting the power cord
Connect the power cord after all component connections have been completed.
Plasma Display (rear view)
Media Receiver (rear view)
Noise filter
Partially eliminates noise
caused by the power source.
Noise filter
Partially eliminates noise
caused by the power source.
PDP5040HD-Eng (17-27) 7/24/03, 6:16 PM 27