Pioneer PureVision PDP 5040HD - Manual (Page 55)

09 Basic Adjustment Settings
English
55
En
No Operation off
The system will be automatically placed into the
standby mode when no operation is performed for
three hours.
1 Press HOME MENU.
2 Press / to select “Power Control”, and then
press ENTER.
3 Press / to select “No Operation off”, and then
press ENTER.
4 Press / to select “Enable”, and then press
ENTER.
Item Description
Disable Does not place the system into the
(factory default) standby mode.
Enable Places the system into the standby mode if
no operation is performed for three hours.
5 Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the
standby mode, a message appears every minute.
Power Control for PC source
Power Management
The system will be automatically placed into the
standby mode when no signal is received from the
personal computer.
1 Press HOME MENU.
2 Press / to select “Power Control”, and then
press ENTER.
3 Press / to select “Power Management”, and
then press ENTER.
4 Press / to select “Mode 1”or”Mode 2”, and
then press ENTER.
Item Description
Off No power management
(factory default)
Mode 1 • Places the system into the standby mode
when no signal is received from the
personal computer for eight minutes.
• Even when you start using the computer
and a signal is received again, the system
stays off.
• The system is switched on again by
pressing STANDBY/ON on the Plasma
Display or TVa on the remote control
unit.
Mode 2 • Places the system into the standby mode
when no signal is received for eight
seconds.
• When you start using the computer and
a signal is received again, the system is
switched on.
• The system is switched on again by
pressing STANDBY/ON on the Plasma
Display or TVa on the remote control
unit.
5 Press HOME MENU to exit the menu.
PDP5040HD-Eng (40-55) 7/24/03, 1:59 PM 55