NEC Dterm PSIII - Manual (Page 14)

8
Searching the Directory by Name:
♦ While in a standby state, press the Scroll S
key.
PSIII displays:
♦ Key in the first few letters of the Person’s last
name and then push the down key. The PSIII will
display names that start with those letters. If you
enter one character, the names that start with that
character will be displayed. When you enter two
characters, names that start with those characters,
will be displayed, and so on.
♦ If the name you’re looking for is not displayed,
use the Scroll T or Scroll S keys to locate the
next name and number. Continue to press the
Scroll
T
or Scroll
S
keys until you locate the
desired name.
♦ Press L1 or L2* to dial the number.
♦ To make another selection, press the END/PWR
key, and then repeat above steps.
* Mode 2 features are only available on NEAX 2000 IVS Series 1900 software
or NEAX 2400 IMX Series 7300 software & Zone Transceiver Version 5.00
software or later.
T O U SE L AST N UMBER R EDIAL
The D term PSIII retains the last 20 numbers you have
called.
♦ While the phone is in a standby state, press the
Scroll
W
key.
♦ The PSIII will display the last number dialed.
♦ If that is the number you wish to dial, press L1or
L2*.
♦ If that is not the number you wish to dial, press the
Scroll T key to scroll through the last 20 numbers
dialed.
NOTE: If you dial the same number several
times, only the latest dialed information will be
displayed.
* Mode 2 features are only available on NEAX 2000 IVS Series 1900 software
or NEAX 2400 IMX Series 7300 software & Zone Transceiver Version 5.00
software or later.
T O U SE S PEED D IAL
♦ While in a standby state, press the Scroll T key.
PSIII displays:
v
Directory
Speed Dial
(0-9)