NEC Dterm PSIII - Manual (Page 25)

19
T O A DJUST C ALL V OLUME
While you are speaking on the phone, the PSIII will
display:
♦ Press the Scroll W or Scroll X key to adjust Call
Volume, the PSIII will display:
♦ Press the Scroll W
key to lower or Scroll
X
key to
increase Call Volume.
NOTE: In the stand by state, press the FNC key →3→1→1.
Operation and the display are the same to those above.
T O U SE I NCOMING C ALL V IBRATION N OTIFI -
CATION
NOTE: Incoming call vibration notification is not
active when either L1
or L2* is busy.
To Enable Incoming Call Vibration Notifica-
tion:
♦ Press the FNC key →3→1→2. PSIII displays:
♦ Select [1] On, then press the FNC key or 1.
♦ After two seconds, the incoming call vibration
notification (“V”) will appear on the LCD.
* Mode 2 features are only available on NEAX 2000 IVS Series 1900 software
or NEAX 2400 IMX Series 7300 software & Zone Transceiver Version 5.00
software or later.
C.Cross
95551212
L 1
Call Volume
Maximum
L 1
Vibration
[1]On
[2]Off