NEC Dterm PSIII - Manual (Page 41)

35
[Call Forwarding No Response]
To set the access code to establish call forwarding
when the handset is not within the wireless system
service area or is turned off.
NOTE: Confirm your system administrator for
the list of access codes.
To Set the Call Forwarding No Response
Access Code:
♦ Press the FNC key →3→5→4. PSIII displays:
♦ Press the FNC key or 1. For Mode 2* systems,
PSIII displays:
♦ Key in the access code to establish Call
Forwarding when No Response.
Example: *9=Call Forward-NR, SET.
♦ Press the FNC key to enter.
♦ Press the FNC key to confirm.
♦ Setting tone will ring.
♦ After two seconds, return to the standby state.
To Set the Call Forwarding No Response Can-
cel Access Code:
♦ Press the FNC key →3→5→4. PSIII displays:
♦ Press the FNC key or 2. For Mode 2* systems,
PSIII displays:
♦ Key in the access code to cancel Call Forwarding.
Example: #9=Call Forward-NR, Cancel.
* Mode 2 features are only available on NEAX 2000 IVS Series 1900 software
or NEAX 2400 IMX Series 7300 software & Zone Transceiver Version 5.00
software or later.
[1]Set
[2]Reset
CFW N/R
Access No?
[1]Set
[2]Reset
CFW N/R
Access No?