NEC Dterm PSIII - Manual (Page 37)

31
♦ Select L1 or L2* by using the Scroll S or Scroll T
key. For Mode 2* systems, PSIII displays:
♦ Press the Scroll W
or Scroll
X
or the number key to
select different Trunk Ring pattern.
♦ Press the FNC key to confirm.
♦ Setting tone will ring.
♦ After two seconds, return to the standby state.
NOTE: The default Trunk Ring pattern is 2.
T O S ET C ALL F ORWARDING
[Call Forwarding Busy]
Enables you to set the access code which is used to
establish call forwarding when your line is busy.
NOTE: Check with your system administrator for
the list of access codes.
To Set the Call Forwarding Busy Access Code:
♦ Press the FNC key →3→5→1. PSIII displays:
♦ Press the FNC key or 1. For Mode 2* systems,
PSIII displays:
♦ Key in the access code to establish call forwarding
when busy.
Example: *3=Call Forward Busy, SET.
♦ Press the FNC key to enter.
♦ Press the FNC key to confirm.
♦ Setting tone will ring.
♦ After two seconds, return to the standby state.
* Mode 2 features are only available on NEAX 2000 IVS Series 1900 software
or NEAX 2400 IMX Series 7300 software & Zone Transceiver Version 5.00
software or later.
[1]L1
[2]L2
Trunk Ring
1 2 3 4 5 6 7 8
Trunk Ring
[1]Set
[2]Reset
CFW Busy
Access No?