NEC Projector VT560 - Manual (Page 10)

10 of 15 Replacing an NEC VT560 Projector (03-00060) in a 2000i-DVX 99-00590-00 Rev A0
NOTE: Two or three turns should be enough to raise the image and close the three inch gap. Ensure that at least one
thread of the bolt protrudes through the nut. It may be difficult to actually see these threads, so you may need to reach
inside the access hole and feel the threads with your fingers.
8. Enlarge the image to fill the screen as follows:
a. Using the security key, loosen the three screws (and washers) that secure the projector to the projector plate.
b. Move the projector backwards (away from the screen) until the image enlarges enough to fill the screen.
c. Tighten the screws and washers you previously loosened.
Electronics Tray
x3