NEC Projector VT560 - Manual (Page 4)

4 of 15 Replacing an NEC VT560 Projector (03-00060) in a 2000i-DVX 99-00590-00 Rev A0
1. Remove the lens cap.
2. Set the new projector upside down on the table, and place the three spacers (removed in the previous procedure) over
the three holes in the base.
3. Place the projector plate over the three spacers, and then insert the three sets of TORX security button-head screws,
split washers and flat washers (removed in the previous procedure) through the slots in the plate and into the three
spacers. We recommend that you position the plate so that the slots are centered over the spacers.
To install the replacement projector
IMPORTANT
Assemble the security screws, split washers and flat washers in the order shown in the figure above.
Spacer (x 3)
Screw (x3)
Split Washer (x3)
Flat Washer (x3)
Spacer (x3)
Projector Plate