NEC Projector VT560 - Manual (Page 5)

99-00590-00 Rev A0 Replacing an NEC VT560 Projector (03-00060) in a 2000i-DVX 5 of 15
4. Tighten the screws with the security key.
5. Note the Mount Location label on the projector (near the projector service label), and make sure you position the
replacement projector in the indicated number and letter mount positions. You can also find the number and letter
mount locations in the Projector Mount Location Guide provided with the replacement projector.
6. While a second person holds the projector (and its attached plate) in place, use the security key to secure the assembly
to the appropriate number and letter locations on the left and right sides of the platform, using the four sets of button-
head screws, split washers and flat washers you removed previously. Make sure the screws are tightly secured.
NOTE: Depending on the height of the projected image, further adjustments may be necessary later on. If the image is
too low on the screen (with a gap of 3.5" or greater between the image and the top frame of the cabinet), you may need
to raise the projector to a higher screw location. This adjustment is discussed in detail on page 9 (step 6).
Number mount
location
Letter mount
location