Important, Caution, Rgb 1 in – NEC Projector VT560 User Manual
Page 2
2 of 15
Replacing an NEC VT560 Projector (03-00060) in a 2000i-DVX
99-00590-00 Rev A0
5. Switch the projector off, and then unplug the AC power, PC Control and RGB 1 IN connectors from the back of the
projector.
.
6. Using a pair of small wire cutters, snip the plastic tie wraps that secure the cables to the projector plate (if necessary).
7. While a second person supports the projector, use the security key to loosen and then remove the four button head
screws (and the accompanying flat and split washers) that hold the projector/projector plate assembly to the two sides
of the projector platform. Carefully collect and place the four screws and eight washers nearby, as you’ll need them
when you install the replacement projector.
IMPORTANT
Take note of the cable connectors as you disconnect them, as you’ll connect them to the same ports in
the replacement projector.
CAUTION
When using wire cutters to cut a tie wrap, be very careful not to gouge the adjacent cables.
CAUTION
A second person must support the base of the projector during the entire removal process. Otherwise,
the projector could fall and sustain damage.
VI DE
O
I N
R
AUD
IO
L/ M
O NO
A UD
I O
O UT
S-VI
DE
O
IN
R
A UD
IO
P C
C ON
TRO
L
A C
IN
R GB
OU
T
L/M
ONO
R G
B IN
AUD
IO
U SB(
P C)
RGB 1 IN
PC Control
Projector
AC