NEC GT6000 - Manual (Page 104)

10-9
m REMOTE 1 Connector
5 1 4 2 3
10
11 12 13 14 15
6 9 7 8
This connector is used for a third party external control device.
Pin No.
14
5
10
3
4,8,12,11
SHORT/OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
FUNCTION
External control mode ON
External control mode OFF
POWER ON
POWER OFF
PICTURE MUTE ON
PICTURE MUTE OFF
MUTE SOUND ON
MUTE SOUND OFF
* When combinations other than specified in the above table are selected or when no optional board is inserted in the Slot 1
and 2, the input will be switched to RGB 1 by default.
* The term “SHORT” means to connect with pin 15
* When in the external control mode, the POWER, Source/Input, PICTURE MUTE and SOUND MUTE buttons on the remote
control will not function.
* When the External control mode is set to ON, the following settings are not effective: Source Select, Auto Start, Power
Management, Power off Confirmation, Idle mode, Default Source Select, Timer and Test Pattern.
NOTE: When turning off the power to the projector using the external control, do not disconnect the plug from the power outlet. These
procedures are to protect your projector and the connected equipment.
11pin
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
SHORT
SHORT
SHORT
SHORT
SHORT
SHORT
12pin
OPEN
OPEN
OPEN
SHORT
SHORT
SHORT
SHORT
OPEN
OPEN
OPEN
SHORT
SHORT
SHORT
8pin
OPEN
OPEN
SHORT
OPEN
OPEN
SHORT
SHORT
OPEN
OPEN
SHORT
OPEN
OPEN
SHORT
4pin
OPEN
SHORT
OPEN
OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
SHORT
OPEN
SHORT
OPEN
RGB 1
VIDEO
S-VIDEO
Slot 1-1
RGB 2
Slot 1-2
RGB1 (S-VIDEO)
DVI (DIGITAL)
VIEWER
RGB1 (VIDEO)
Slot 2-1
Slot 2-2
LAN
10. Appendix