NEC GT6000 - Manual (Page 35)

3-5
3. Press the 3D REFORM button on the remote control.
The Cornerstone adjustment screen is displayed.
The Cornerstone adjustment screen will disappear when you move the
USB mouse cursor.
4. Point to one of the remaining 3 corners and left-click on it.
Screen
5. Do the above step 4 for the other two corners so that the projected area
becomes smaller than the screen.
Screen
Left-click on each corner.
Left-click on the corner.
Screen
Projected image
(The drawing shows the upper right corner.)
3. Press the 3D REFORM button on the projector or the KEYSTONE but-
ton on the remote control.
The Cornerstone adjustment screen is displayed.
NOTE: Press the 3D REFORM button to toggle between "Cornerstone" and "Key-
stone."
When using the remote control or cabinet buttons:
1. Project an image so that the screen is smaller than the area of the
raster.
2. Pick up any one of the corners and align the corner of the screen with
the one of the image.
6. To complete the procedure, right-click anywhere on the screen.
The confirmation screen is displayed.
7. Left-click on "OK".
This completes the Cornerstone adjustment.
* To return the Cornerstone adjustment to the default settings, left-click
on "Reset" in Step 7.
You can save your Cornerstone changes. The changes are saved when
you turn off the projector. To do so, select [Projector Options]
→ [Setup] →
[Page 4]. Select the 3D Reform Save check box. This is not selected at the
time of shipment.
* There are limitations of shapes which can be corrected using the Cor-
nerstone adjustment.
When adjusting the Cornerstone beyond these limits, you will get the mes-
sage "Out of adjustment range!" and no correction can be done. Should
this happen, do the Cornerstone adjustment again within the allowable
range.
* Due to limitations of accuracy within internal processes, there may be
some discrepancy of positions between the mouse cursor and corrected
shape or one corner and the other 3 corners.
3. Projecting an Image
5. Press the ENTER button.
6. Use the SELECT ̆̄̇̈ button to move the projected image frame as
shown on the example.
7. Press the ENTER button.
Screen
Screen
4. Use the SELECT ̆̄̇̈ button to select one icon which points in the
direction you wish to move the projected image frame.