NEC GT6000 - Manual (Page 14)

1-10
1. Introduction
OFF
+ -
PICTURE
ADJUST
ABC DEF GHI
JKL MNO PQR
STU
,. UNDO CANCEL
TEST
PICTURE
KEYSTONE AMPLITUDE ENTRYLIST
SOUND OSD
MUTE
MAGNIFY
HELP INFO.
POSITION AUTO PIXEL
VWX YZ/
WHITE BAL.
IMAGE
ON
POWER
MENU
ENTER
1 2 3
4 5 6
7
0
8 9
ADDRESS
PROJECTOR
R G B
LENS
SHUTTER
BS
+
-
+
-
FOCUS ZOOM
CTL
LENS
2
5
6
7
9
10
12
13
17
20
21
22
24
26
25
23
19
18
16
15
14
11
8
4
3
1
v Remote Control Features 1. POWER ON
Press and hold this button for a minimum of two seconds to
turn on the projector when the main power is supplied and the
projector is in standby mode or idle mode.
2. POWER OFF
Press and hold this button for a minimum of two seconds to
turn off the projector.
3. MENU
Press to display the main menu.
While pressing and holding CTL, press this button to display
the Remote Control ID dialog box to specify the remote control
ID. See page 7-2.
4. ENTER
Executes the menu selection and activates items selected from
the menu. When the slider or dialog box is displayed:
Pressing this button confirms adjustments/setting and returns
to the previous menu display.
5. Select (Up/Down/Left/Right)
̆̄: Use these buttons to select the menu of the item you
wish to adjust.
When no menus appear, these buttons work as a volume
control.
̇̈:
Use these buttons to change the level of a selected
menu item.
A press of the
̈ button executes the selection.
Pressing and holding CTL, then pressing
̇ button works as a
Back Space key in the entry screen.
Pressing and holding CTL, then pressing this button moves
the menu, slider, toolbar or dialog box.
6. ADJUST WHITE BAL.
Press to display the Picture Management screen.
7. ADJUST PICTURE
Press to display the Picture adjustment screen. Pressing this
button sequentially selects adjustment screens.
8. IMAGE/PROJECTOR
Press to display the Image Option screen. Pressing this button
sequentially selects Image Options screens.
While pressing and holding CTL, pressing this button rotates
Projector Options screens.
9. Source / Input
Press to select input or to name a signal.
1 Selects RGB 1 input.
2 Selects RGB 2 input.
3 Selects DVI (DIGITAL) input.
4 Selects VIDEO input.
5 Selects S-VIDEO input.
6 Selects Viewer input
7 Selects LAN input
8 Selects OPTION SLOT 1* (available for optional SDI board)
9 Selects OPTION SLOT 2* (available for optional SDI board)
0 Sequentially selects: RGB1 (VIDEO) → RGB1 (S-VIDEO) .
* This button toggles between input 1 and 2.
NOTE: While pressing and holding CTL, pressing this button switches to the
selected signal found in the Entry List.