NETGEAR ADSL2+ Modem Router DM111PSPv2 - Manual (Page 78)

ADSL2+ Modem Router DM111PSPv2 User Manual
6-6 Troubleshooting
v1.0, December 2008
Modem Router Does Not Save Configuration Changes
If the modem router does not save changes you have made, check the following:
• When entering configuration settings, be sure to click the Apply button before moving to
another screen, or your changes are lost.
• Click the Refresh or Reload button in the Web browser. The changes may have occurred, but
the Web browser may be caching the old configuration.
Troubleshooting the Internet Connection
If your computer is connected to your modem router via a router, disconnect the router and directly
connect the computer to the modem router. If you now have Internet access, use the documentation
that came with the router to perform re-installation and troubleshooting.
If your modem router is unable to access the internet, but your Internet LED is green or blinking
green, you should determine whether the modem router is able to obtain an IP address from the
ISP. Unless you have been assigned a static IP address, your modem router must request an IP
address from the ISP. You can determine whether the request was successful using the browser
interface.
To check the WAN IP address from the browser interface:
1. Launch your browser and select an external site such as www.netgear.com .
2. Access the management interface of the modem router using your browser. For details, see
“Logging In to the Modem Router” on page 1-2 .
3. Under the Maintenance heading select Modem Status. Check that an IP address is shown for
the ADSL port. If 0.0.0.0 is shown, your modem router has not obtained an IP address from
your ISP.
If your modem router is unable to obtain an IP address from the ISP, check the following:
• Your ISP may require a multiplexing method or Virtual Path Identifier/Virtual Channel
Identifier parameter.
Verify with your ISP the multiplexing method and parameter value, and update the modem
router’s ADSL settings accordingly.
• If your ISP requires PPP over Ethernet (PPPoE) or PPP over ATM (PPPoA), check that your
login credentials are correct.