Nokia MW1122 - Manual (Page 16)

Applications and features
E Copyright Nokia Networks Oy C33902001SE_00 2-5
2.2.1 Interfaces
MW1122 has the following interfaces:
D Ethernet interface (LAN)
D Wireless LAN interface (WLAN)
D 8 ATM VCC interfaces
D ATM VCC management interface
D Gateway/bridge management interface. This interface is used as a
bridge host interface or gateway interface depending on the
operation mode. In this manual it is called VBRIDGE. On the
MW1122 web pages, the interface is called gateway or bridge IP
interface.
MW1122 can operate in four different main modes:
D Bridging only
D Routing/tunneling IP only
D Routing/tunneling IP, bridging all but IP
D Routing/tunneling IP and bridging all, including IP
The mode in which MW1122 operates depends on the configuration of
the unit’s interfaces. Table 2-1 shows the operational modes and the
corresponding interface configurations.
LAN interface WLAN inter-
face ATM VCC inter-
faces Vbridge
(gateway/host
interface)
Bridge only
Bridging Bridging or
slaved to LAN
interface (single
subnet). Bridging. Used as a man-
agement (host)
interface for all
bridged inter-
faces in case
such is needed.
Route/tunnel IP only
Routing (IP ad-
dress confi-
gured) Routing (IP ad-
dress confi-
gured) or slaved
to LAN interface
(single subnet). Routing (IP ad-
dress confi-
gured) or PPTP
local tunneling
activated for
each active
ATM VCC. Not used in this
case. The unit
can be man-
aged through
any of the LAN,
WLAN or ATM
interface IP ad-
dresses.