Nokia MW1122 - Manual (Page 40)

Managing MW1122
E Copyright Nokia Networks Oy C33902001SE_00 5-5
MW1122> show config running
eth
ip address 192.168.1.1 255.255.255.0
wlan
network-name nokia
radio-channel europe 13
slave-to–eth
vcc1
pvc 0 100 ip-llc
ip address 10.98.16.1 255.255.255.0
MW1122>
5.2 Typical configuration tasks
This section provides some typical configuration tasks. These
configuration examples can be done through the command line
interface.
Note
After you have made changes to the configuration, you must save the
configuration if you want it to be active also after restarting MW1122.
5.2.1 Configuring DHCP and DNS
The DHCP server can be enabled towards LAN, WLAN, and
VBRIDGE ports. When the DHCP server is enabled, up to two address
ranges (scopes) will be automatically generated and bound to
LAN/WLAN/VBRIDGE interfaces, in this order if the interface has an
IP address. Two address ranges will be required when LAN and
WLAN interfaces separate IP addresses resulting that two different
address spaces will be used, one for each interface.
The address range defines pool of IP addresses and parameters like
default gateway, DNS addresses and domain name. The generated
default address range allows up to 253 IP addresses (C class).
Automatically generated address ranges use LAN/WLAN/VBRIDGE
IP address as gateway and DNS server addresses. If one address range
is defined, then automatic binding will be disabled. If optional address
range parameters like gateway or DNS addresses are not defined,
LAN/WLAN/VBRIDGE IP addresses are used as in automatic
binding.