Nokia MW1122 - Manual (Page 45)

MW1122 Administrator Manual
E Copyright Nokia Networks Oy C33902001SE_00 5-10
Note
You must activate the admission control to prohibit other WLAN
clients from entering your network.
To activate the access list:
1. Open a telnet or CLI session to MW1122 as described earlier in
this chapter.Start the configuration mode by typing
configure
ENTER
.
2. Go to wlan configuration level by typing wlan ENTER
.
3. Activate the access list by giving the admission-control
sta-address ENTER
command. You can deactivate admission
control by typing no admission-control ENTER
.
4. Type
show
on the wlan configuration level to view the activated
access list entries.
5.2.5 File system and downloading new firmware using TFTP
MW1122 has a flash file system. Some files in the file system have
special meanings. These files are:
D image.exe; primary application file.
D image.bak; secondary application file used if image.exe has been
corrupted or is missing. It is then renamed as image.exe
automatically.
D startup.cfg; primary configuration file used during startup.
D dhcp.leases; contains DHCP lease table information.
MW1122 has the following commands that can be used for file
handling:
D copy
D rename
D delete
D dir
If you use image.exe as a destination filename with the copy command
and the image.exe already exists, the existing image.exe will be
automatically renamed as image.bak. This guarantees that the
application file exists if MW1122 loses power during SW download.
You can update the operating software of MW1122 by downloading
the new software from a TFTP server. To download and activate new
MW1122 operating software: