Installation, Selecting a location, Screen size and projection distance – NEC XL-3500 User Manual

Page 16: Pulling out the handles, Retracting the handles, Setting up your multisync hivid 3500 projector, Moving the projector

Advertising

123456

2. INSTALLATION

Selecting A Location

The further your projector is from the screen or wall, the larger the image. The minimum size the image can be

projected is 80" (2 m) measured diagonally. The largest the image can be is 500" (12.7 m).

WARNING
• Only use your projector on a solid, level surface. If the projector falls to the ground, you can be injured and

the projector severely damaged.

• Do not use the projector where temperatures vary greatly. The projector must be used at temperatures

between 32 degrees F (0 degree C) and 104 degrees F (40 degree C).

• Do not expose the projector to moisture, dust, or smoke. This will harm the screen image.

• Ensure that you have adequate ventilation around your projector so heat can dissipate. Do not cover the

vents on the bottom or back of the projector.

Screen Size and Projection Distance

1. Place your projector on a flat level surface at

the optimal distance from the screen or wall so

you realize the size image you want. (Avoid

having bright room lighting or sun light

directly on the screen or wall where you’ll be

projecting the image.)

2. Connect the power cable, remove the lens cap

and turn the projector on. (If no input signal is

available, the projector will display a black

screen.)

3. Ensure that the projector is square to the

screen.

4. Move the projector left or right to center the

image horizontally on the screen.

Pulling Out the Handles

Pull out the handle from the bottom side.

Retracting the Handles

Press down the two levers at the same time to retract the

handle.

Setting Up Your MultiSync Hivid 3500 Projector

To set up and use your MultiSync Hivid 3500 Projector, you

must first do:

1. Determine the screen size and the optional lens to be used.

NOTE: Consult your dealer for lens order and installation.

2. Set up a screen or select a non-glossy white wall onto

which you can project your image.

Moving The Projector

Always carry your projector by the handle. Ensure that the

power cord and any other cables connecting to video sources

are disconnected before moving the projector. When moving

the projector or when it is not in use, cover the lens with the

lens cap.

АА

This section describes how to set up your MultiSync Hivid 3500 projector and how to connect video and audio sources.

Projector

Screen

Lens center

Screen center

Projector

Screen

Advertising

Popular Brands

Popular manuals