NEC XL-3500 User Manual

Page 3

Advertising
background image

3

INTRODUCTION

Important Safeguards

These safety instructions are to ensure the long life of your projector and to prevent fire and shock. Please read them carefully and heed
all warnings.

Installation

1. Place the projector on a flat, level surface and in a dry area free from dust and moisture.
2. Do not place the projector in direct sunlight, near heaters or heat radiating appliances.
3. Exposure to direct sunlight, smoke or steam could harm internal components.
4. Handle your projector carefully. Dropping or jarring your projector could damage internal components.
5. Do not place heavy objects on top of the projector.
6. If installing the projector on the ceiling:

a. The ceiling must be strong enough to support the projector and the installation must be performed in accordance with any local

building codes.

b. Qualified NEC authorized dealer personnel must install the projector.

Power Supply

1. The projector is designed to operate on a power supply of 2.3KW(MAX) AC200-240V 50/60Hz. Ensure that your power supply fits

this requirement before attempting to use your projector.

2. Handle the power cable carefully and avoid excessive bending. A damaged cord can cause electric shock or fire.
3. If the projector will not be used for an extended period of time, disconnect the plug from the power outlet.
4. Placing the power cord and the RGB cable closely to each other can cause beat noise. If this happens, keep the two separated until

beat noise is not generated

Cleaning

1. Unplug the projector before cleaning.
2. Clean the cabinet periodically with a damp cloth. If heavily soiled, use a mild detergent. Never use strong detergents or solvents such

as alcohol or thinner.

3. Use a blower or lens paper to clean the lens, and be careful not to scratch or mar the lens.

Fire and Shock Precautions

1. Ensure that there is sufficient ventilation and that vents are unobstructed to prevent potentially dangerous concentrations of ozone

and the build-up of heat inside your projector. Allow at least 3 inches (10cm) of space between your projector and a wall.

2. Prevent foreign objects such as paper clips and bits of paper from falling into your projector. Do not attempt to retrieve any objects

that might fall into your projector. Do not insert any metal objects such as a wire or screwdriver into your projector. If something
should fall into your projector, disconnect it immediately and have the object removed by a qualified NEC service person.

3. Do not place any liquids on top of your projector.

CAUTION:

High Pressure Lamp May Explode if Improperly Handled. Refer Servicing to Qualified Service Personnel.

Lamp Caution: Please read before operation

Due to the lamp being sealed in a pressurized environment, there is a small risk of explosion, if not operated correctly. There is
minimal risk involved, if the unit is proper working order, but if damaged or operated beyond the recommended 1500 hours, the
risk of explosion increases.

Please note that there is a warning system built in, that displays the following message when you reach 1500 hours of operation”
Lamp Running Time is Over 1500 Hours!!” When you see this message please contact your NEC Dealer for a replacement.

If the lamp does explode, smoke will be discharged from the vents located on the side of the unit. This smoke is comprised of
glass in particulate form and Xenon gas, and will not cause harm if kept out of your eyes. If your eyes have been exposed to this
gas, please flush your eyes out with water immediately and seek immediate medical attention. Do not rub your eyes! This could
cause serious injury.

WARNING:Do not look into the lens while the projector is on. Serious damage to your eyes could result.

Advertising