NEC XL-3500 - Manual (Page 34)

34
3.OPERATION
You can select the input terminal for the registered signal. This
feature is useful when you need to change the input terminal due
to adding optional equipment.
NOTE: This setting cannot be done to the current projected
signal.
When used in the stand alone operation:
Use the CURSOR or button to select an input slot from
three slots: INPUT A, INPUT B, and INPUT C, and press
ENTER.
Items to select
• INPUT A .............. Standard installed terminal
• INPUT B .............. Optional board terminal
• INPUT C .............. Optional board terminal
When used with a single Switcher ISS-6020/ISS-6020G:
Use the CURSOR or button to select the desired slot
number "1" through "10" of the Switcher and press ENTER.
When used with two or more Switchers ISS-6020/ISS-6020G:
Use the CURSOR or button to select the master slot
number "1" through "10" first from the master menu, then select
the slave slot number "1" through "10" from the slave menu and
press ENTER.
■ Input Slot
S e l e c t T e r m i n a l
1 . I N P U T - A
2 . I N P U T - B
3 . I N P U T - C
S L O T – 0 1
S L O T – 0 2
S L O T – 0 3
S L O T – 0 4
S L O T – 0 5
S L O T – 0 6
S L O T – 0 7
S L O T – 0 8
S L O T – 0 9
S L O T – 1 0
M A S T E R
S L O T – 0 1
S L O T – 0 2
S L O T – 0 3
S L O T – 0 4
S L O T – 0 5
S L O T – 0 6
S L O T – 0 7
S L O T – 0 8
S L O T – 0 9
S L O T – 1 0
M A S T E R
S L O T – 0 1
S L O T – 0 2
S L O T – 0 3
S L O T – 0 4
S L O T – 0 5
S L O T – 0 6
S L O T – 0 7
S L O T – 0 8
S L O T – 0 9
S L O T – 1 0
S L A V E