NEC XL-3500 - Manual (Page 52)

52
3.OPERATION
Set Option
Passcode
■ Entering Passcode
To prevent any unauthorized operation or mis-adjustment, the
projector is equipped with a passcode option. If your passcode has
not been entered correctly, the “Adjustment” menu will not be
displayed. When the ADJUST button is pressed, and no passcode has
been entered, the “Passcode?” screen is displayed. Enter your
passcode.
To do this, proceed as follows:
1 Press the ADJUST button.
• The “Passcode?” screen is displayed.
2 Enter the four digit passcode you have already registered by
using the “1” through “10” buttons.
1) Each time you press the INPUT button, an asterisk appears
under the “Passcode?” message.
2) After you have finished entering the four digit passcode, press
ENTER.
NOTE: If you have made an error, press the NORMAL button to
delete the asterisk “*”. Then re-enter the correct passcode. To
delete all the entered digits, hold down the CTL button then
press the NORMAL button.
3) If the entered passcode is correct, the “ADJUST” menu is
displayed.
NOTE: If the passcode is not correct, the “Warning Different
Passcode!!” message is displayed and you are required to enter
the correct passcode.
3 Proceed to each adjustment and setting.
P a s s c o d e ?
∗∗∗∗