Windows nt using dlc protocol – NEC SILENTWRIT 1700 Series User Manual
Page 78
4–30
1765 Network Printer Configuration Guide
Windows NT Using DLC Protocol
Before you begin you will need to know the LAN card
name and MAC Address. This information is included
on the configuration page. See “Print a Configuration
Page” on page 2-13.
The following steps summarize how to connect your
Silentwriter.
1.
Install software.
2.
Identify the printer.
3.
Establish the printer on the network.
These are described in detail below.
Install the Software
1.
From Windows NT open the Main icon.
2.
Open the Control Panel icon, then select the
Network
control panel.
3.
If DLC Protocol is not listed under Installed
Network Software, select Add Software from the
Network Settings dialog box. Otherwise, skip to
step 6.
4.
Select DLC Protocol from the Add Software dialog
box. Click Continue.
5.
You will need your Windows NT system diskettes
or CD-ROM. In the Windows NT Setup dialog box
enter the directory for the Windows NT disk. Click
Continue
.
6.
Select OK to leave the Network Settings dialog box.
7.
If you have just installed DLC Protocol, restart your
computer.