NEC MT 1020G /820G - Manual (Page 13)

E – 13
This section describes how to set up your MultiSync
MT1020G/820G LCD projector and how to connect video
and audio sources.
Setting Up Your MultiSync
MT1020G/820G LCD Projector
Your MultiSync MT1020G/820G LCD Projector is simple
to set up and use. But before you get started, you must first:
1. Determine the image size
2. Set up a screen or select a non-glossy white wall onto
which you can project your image.
Carrying The LCD Projector Always carry your LCD
projector by the handle. Ensure that the power cord and
any other cables connecting to video sources are discon-
nected before moving the projector. When moving the
projector or when it is not in use, cover the lens with the
lens cap.
Selecting A Location The further your LCD projector is
from the screen or wall, the larger the image. The mini-
mum size the image can be is approximately 20" (0.5 m)
measured diagonally when the projector is roughly 1.0 m
(3 feet) from the wall or screen. The largest the image can
be is 300" (7.6 m) when the projector is about 12.2 m
(40.03 feet) from the wall or screen.
Using the Supplied Lift Kit
When you need to set the projector at 10.5
°
projection angle
or more, assemble and use the lift kit.
1. Assemble the kit.
I N S T A L L A T I O N
2
• Align the foot and mate with corresponding grooves in the
bar.
2. Place the projector on the lift kit.
350
300
250
200
150
100
50
0
0.0 6.56 13.12 19.69 26.25 32.81 40.03 ft.
(2.0) (4.0) (6.0) (8.0) (10.0) (12.2) (m)
Projection Distance
Diagonal Image Size (inch)
Projection Distance and Image Size
300”
235”
WIDE
TELE
27”
20”
Width
Height
Screen size
(diagonal)
Projection distance
Carrying handle
Push to release the
handle.
Pull out
Push to retract