NEC MT 1020G /820G - Manual (Page 8)

E – 8
FOCUS
ZOOM
ADJUST
ENTER
SELECT
MENU
POWER
ON/OFF STATUS PUSH
Top Features
7
6
5
4
3
2
1
9
8
1 Power Button
Use this button to turn the power on and off when Main
Power Switch is on and the LCD projector is on standby.
(When this button is pressed and held for at least two
seconds, the “Display Mute” mode will be canceled.)
2 Menu Button
Displays the on- screen menu.
3 Select Button
After you press the “Menu” button, use this button to
select the menu icon of the item you wish to adjust.
4 Enter Button
Executes your menu selection.
5 (+) (–) Adjust Button
Use these buttons while you' re in the Image Adjust mode
to change the level of a selected menu item. These but-
tons are also used to set an item in the Power or Settings
menus.
6 (+) (–) Zoom Buttons
Press the (+) button to make the image larger; press (–) to
make the image smaller.
7 (+) (–) Focus Buttons
Press the (+) or (–) buttons to focus an image.
8 Power Indicator
When this indicator is green, the LCD projector is on;
when the indicator is amber, it is standing by.
9 Status Indicator
When this is lit red continually, it's warning you that the
projection lamp has exceed 2000 hours of service. After
this light appears, it is advisable to replace the projection
lamp as soon as possible.(See page E-28.)
When the operating time of the lamp exceeds 2000 hours,
the STATUS indicator is lit red continually. In addition
the message "LAMP USAGE XX HOURS" appears con-
tinually when the on-screen menu is not displayed.
If this light blinks red rapidly, it indicates that either the
lamp cover or filter cover is not attached properly; if the
light blinks slowly it means the projector's internal tem-
perature is too hot to operate safely. See the Status Light
Messages on page E-30 for more details.