NEC MT 1020G /820G - Manual (Page 14)

E – 14
Using A Tabletop Or Cart
1. Place your LCD projector on a flat level surface at the
optimal distance from the screen or wall so you realize
the size image you want. (Avoid having bright room
lighting or sun light directly on the screen or wall where
you'll be projecting the image.)
2. Connect the power cable, remove the lens cap and turn
the projector on. (If no input signal is available, the
projector will display a background image.)
3. Ensure that the projector is square to the screen.
4. Move the projector left or right to center the image hori-
zontally on the screen. (A)
5. To center the image vertically (B), lift the front edge of
the projector and press the buttons on the front of the
projector, just above the feet, to release the one-touch tilt
feet. (There is approximately 10.5˚ of up and down ad-
justment for the front of the projector. When you need to
set the projector at 10.5
°
projection angle or more, use
the lift kit that is supplied.)
6. To fine tune the image's position vertically on the screen,
rotate each front foot.
7. Increase or reduce the size of the projected image by
pressing the "Zoom" (+) or (–) buttons on the remote
control or top of the cabinet.
FOCUS ZOOM ADJUST
ENTER SELECT MENU POWER ON/OFF
STATUS
PUSH
(A) Top view
(B) Side view
Screen
Screen