NEC MT 1020G /820G - Manual (Page 5)

E – 5
This section introduces you to your new MultiSync
MT1020G(XGA) or MT820G(SVGA) LCD Projector, pro-
vides a list of materials that comes with your projector and
describes the features and controls.
Congratulations On Your Purchase Of The
MultiSync MT1020G/820G LCD Projector
The MultiSync MT1020G/820G is one of the very best LCD
projectors available today. The multiple LCD panels enable
you to project precise images up to 300 inches across (mea-
sured diagonally) from your PC or Macintosh computer
(desktop or notebook), VCR, document camera, or even a
laser disc player.
You can use the projector on a tabletop or cart, you can
permanently mount it on a ceiling*
1 , or you can use
MultiSync MT1020G/820G LCD Projector to project im-
ages from behind the screen. The remote control can be used
wirelessly or with a cable, and you can even use the remote
control with the remote mouse receiver to operate the mouse
on your PC or Mac. But best of all, the MultiSync
MT1020G/820G is an NEC LCD projector. That means you
can depend on years of reliable performance and crystal-
clear presentations!
The features you’ll enjoy include:
• Simple set up and operation.
• A high-performance 250 watt metal halide lamp that
delivers 700 ANSI lumens (MT1020G: 600 ANSI lu-
mens) and is guaranteed for 2000 hours of service or six
months, whichever comes first.
• A wireless remote control that operates the projector from
any angle.
• A laser pointer that' s built into the remote control.
• The power zoom control enables you to adjust the image
to be between 20 and 300 inches (measured diagonally).
• You can choose between video modes depending on your
source: "normal" for a typical picture, "natural" for true
color reproduction, and "camera" for use with a docu-
ment camera or low APL picture.
I N T R O D U C T I O N
• The "image capture" enables you to use the entire picture
as a background image or to create an image loop.
• An image can be projected from in front or behind a
screen, and the projector can even be installed on the
ceiling.
• Supports most IBM VGA, S-VGA, XGA* 2 , SXGA
(pseudo)* 3 , Macintosh or any other RGB signals within a
horizontal frequency range of 15.625 to 85 kHz
(MT820G: 15.625 to 60 kHz) and a vertical frequency
range of 50 to 85 Hz. This includes NTSC, PAL, SECAM
and NTSC 4.43 standard video signals.
Note: Composite video standards are as follows:
NTSC:
U.S. TV standard for video in U.S. and Canada.
PAL: TV standard used in western Europe
SECAM: TV standard used in France and Eastern Europe
NTSC4.43: TV standard used in Middle East countries
• The remote control can be used with or without a cable,
and you can even use the remote to operate your PC or
Macintosh mouse wirelessly from across the room with
the remote mouse receiver.
• You can control your MultiSync MT1020G/820G LCD
Projector with a PC.
• The contemporary cabinet design is compact, easy to
carry, and complements any office, board room or audito-
rium.
* 1 Installing the MultiSync MT1020G/820G LCD Projector
on the ceiling must be done by authorized NEC techni-
cians.
Consult your NEC dealer for more information.
* 2 An XGA image (1024
ן768) is compressed into
800
ן600 on MT820G.
* 3 An SXGA pseudo image (1280
ן1024) is not supported
by MT820G.
1