NEC MT 1020G /820G - Manual (Page 9)

E – 9
Terminal Panel Features
This panel is located in the rear and is where you connect your
cables.
REMOTE CONTROL
PC
CONTROL
S-VIDEO INPUT
INPUT
VIDEO INPUT AUDIO INPUT
OUTPUT
AUDIO OUTPUT
AUDIO RGB INPUT 1
RGB INPUT 2 AUDIO
DC12V/400mA
OUTPUT
RGB MONITOR OUTPUT
L / MONO R
L / MONO R
1 a 1 b 2 3
4
5
1 Remote Control Jacks
a. Remote Control Input Jack
Connect your remote control cable here for wired opera-
tion.
b. Remote Control Output Jack
This terminal enables you to operate up to five LCD
projectors with the same remote control.
When your remote mouse receiver is connected here, the
remote sensors on the LCD projector cabinet will receive
your mouse commands.
2 PC Control Port
Use this port to connect your PC to control the MultiSync
MT1020G/820G Projector. This enables you to use your
PC and serial communication protocol to control the
projector. If you are writing your own program, com-
mand references are on pages E-36.
3 12V DC/400 mA Output Terminal
Use this terminal to plug in a document camera or any
other 12V accessory.
4 Video Input
Connect a VCR, laser disk player, or document camera
here to project video.
Left Channel/Mono Audio Input Jack
This is your left channel audio input for stereo sound
coming from video equipment or audio system. This also
serves as your monaural audio input.
Right Channel Audio Input Jack
This is your right channel audio input for stereo sound.
5 S-Video Input
Here is where you connect S-Video input from an exter-
nal source like a VCR.
Left Channel/Mono Audio Input Jack
This is your left channel audio input for stereo sound
coming from S-Video equipment or audio system. This
also serves as your monaural audio input.
Right Channel Audio Input Jack
This is your right channel audio input for stereo sound.
NOTE: S-Video provides more vivid color and higher resolution
than the traditional composite video format.