NEC MT 1020G /820G - Manual (Page 22)

E – 22
This section describes how to select a computer or video source and how to adjust the picture and
sound.
General Controls Before you turn on your MultiSync MT1020G/820G LCD Projector, ensure that
the computer or video source is turned on and that your lens cap is removed.
1. Turn On The LCD Projector The main power switch is on the back panel of the MultiSync
MT1020G/820G LCD Projector. By turning this switch on, the projector will go into its standby
mode and the power light will glow amber. Only after you press the "On" button on the remote
control or projector cabinet will the power light turn to green and the projector become ready to
use.
NOTE: To turn the LCD projector on and off with just the back panel switch, use the menu and enable the "auto
start" feature. (See page E-26. )
2. Select The Computer Or Video Source Press the "Video" (VCR, document camera, or laser
disc player), "S-video", "RGB 1" or "RGB 2" (computer) button on the remote control to display
the image. Or press the "Menu" button on the cabinet and use the icons to select your video
source: "Video", "S-Video", "RGB 1" or "RGB 2."
3. Adjust The Image Size Press the "Zoom" button (+) or (–) on the remote control or projector
cabinet to make the image larger or smaller.
4. Focus Press the "Focus" button (+) or (–) on the remote control or projector cabinet to focus the
image.
5. Turning Off The Projector First press the "off" button on the remote control or the projector
cabinet. The power light will glow amber. Then turn off the main power switch on the back panel.
The power light will go out.
IMPORTANT:
• The LCD projector should be unplugged if it will not to be used for an extended period.
• To turn off the image briefly (five minutes or less), use the "Picture Mute" button instead of
turning the projector off and on.
• The LCD projector will display a black, blue, or loop image if no input signal is present.
• Do not turn the LCD projector off and then immediately back on. The projector needs to cool for
a minute before it can be restarted.
O P E R A T I O N
3