Netopia 2200 User Manual
Page 142
142
Add, Edit, or delete exposed addresses options are active only if NAT is disabled on a WAN
inter face. The hosts specified in exposed addresses will be allowed to receive inbound traf-
fic even if there is no corresponding outbound traffic.
•
Start Address: Start IP Address of the exposed host range.
•
End Address: End IP Address of the exposed host range
•
Protocol: Select the Protocol of the traffic to be allowed to the host range from the pull-
down menu. Options are Any, TCP, UDP, or TCP/UDP.
•
Start Port: Start port of the range to be allowed to the host range. The acceptable
range is from 1 - 65535
•
End Port: Protocol of the traffic to be allowed to the host range. The acceptable range
is from 1 - 65535
You can add more exposed addresses by clicking the
Add more Exposed Addresses
link. A list of previously configured exposed addresses appears.