Netopia 2200 - Manual (Page 252)

252
If you specify v2-MD5, you must also specify a rip-send-key. Keys are ASCII strings with a
maximum of 31 characters, and must match the other router(s) keys for proper operation
of MD5 suppor t.
set ip dsl vccn rip-receive
{ off | v1 | v2 | v1-compat | v2-MD5 }
Specifies whether the Netopia Gateway should use Routing Information Protocol (RIP)
broadcasts to update its routing tables with information received from other routers.
If you specify v2-MD5, you must also specify a rip-receive-key. Keys are ASCII strings
with a maximum of 31 characters, and must match the other router(s) keys for proper oper-
ation of MD5 suppor t.
Ethernet LAN Settings
set ip ethernet A option { on | off }
Enables or disables communications through the designated Ethernet por t in the Gateway.
You must enable TCP/IP functions for an Ethernet por t before you can configure its network
settings.
set ip ethernet A address ip_address
Assigns an IP address to the Netopia Gateway on the local area network. The IP address
you assign to the local Ethernet inter face must be unique on your network. By default, the
Netopia Gateway uses 192.168.1.254 as its LAN IP address.
set ip ethernet A broadcast broadcast_address
Specifies the broadcast address for the local Ethernet inter face. IP hosts use the broad-
cast address to send messages to ever y host on your network simultaneously.
The broadcast address for most networks is the network number followed by 255. For
example, the broadcast address for the 192.168.1.0 network would be 192.168.1.255.