Netopia 2200 - Manual (Page 213)

213
Link: DSL: Circuit Configuration
The DSL Circuit Configuration screen shows the traffic sent and received over the DSL line
as well as the trained rate (upstream and downstream) and the VPI/VCI. Verify traffic is
being sent over the DSL line. If not, check the cabling and make sure the Gateway is not
connected to a micro filter. Also verify the correct PVC is listed, which should be 0/35
(some providers use other values, such as 8/35. Check with your provider). If not go to the
WAN setup and change the VPI/VCI to its correct value. Below is an example:
ATM port status : Up
Rx data rate (bps) : 8000
Tx data rate (bps) : 800
ATM Virtual Circuits:
VCC # Type VPI VCI Encapsulation
---- ---- --- ----- --------------------------
1 PVC 8 35 PPP over Ethernet (LLC/SNAP encapsulation)
ATM Circuit Statistics:
Rx Frames : 17092 Tx Frames : 25078
Rx Octets : 905876 Tx Octets : 1329134
Rx Errors : 0 Tx Errors : 0
Rx Discards : 0 Tx Discards : 0
No Rx Buffers : 0 Tx Queue Full : 0