Netopia 2200 - Manual (Page 68)

68
Link: WAN
WAN IP Interfaces
Your IP inter faces are listed. Click on an inter face to configure it.
IP Gateway
Enable Gateway: You can configure the Gateway to send packets to a default gateway
if it does not know how to reach the destination host.
Interface Type: If you have PPPoE enabled, you can specify that packets destined for
unknown hosts will be sent to the gateway being used by the remote PPP peer. If you
select ip-address, you must enter the IP address of a host on a local or remote network
to receive the traffic.
Default Gateway: The IP Address of the default gateway.
Other WAN Options
PPPoE: You can enable or disable PPPoE. This link also allows configuration of NAT,
admin restrictions, PPPoE username/password, and connection type.