NComputing VSPACE L300 - Manual (Page 10)

L300/L230/L130 User Manual
10
L130 and L230 Device Setup
(For L300 devices, see next section)
The access device must be connected via Ethernet to the host PC. This can be done using an Ethernet switch,
a router, or some other network connection method.
Network connection
If the network is configured to use DHCP to get dynamic IP addresses, you can setup the access device to use
it. Turn on the access devices and once you see the main screen select the "Options" button, and then select
the “Setup” button.
In the "Network" tab, select whether to use a dynamic IP address or a static IP address.