NComputing VSPACE L300 - Manual (Page 43)

L300/L230/L130 User Manual
43
In the "USB
-Device Assignment(s)" tree item, you can control connections between USB ports on the host and vSpace
sessions. To use this function, navigate the tree to select a USB port. When you right-click on an entry under
“USB-Device Assignment(s)”, you can de-select the “Hide the ports that are not connected” item to see all
ports. After selecting a port, the following information is displayed:

The port number.

If a device is connected, the device's simple name.

The device's longer name, usually including the manufacturer and model.

A check box for "Allow all users access to every USB port". When this is selected, all USB ports are
connected, as if in one hub. When the box is not checked, a list of available USB ports is displayed
where you can select which one(s) is/are to be connected to the selected device. This list shows each
access device's MAC address and its serial number along with a checkbox.
When you click on the "Apply" button, changes to the USB-Device assignments are saved. To discard
changes, simply navigate to another tree item or close the console without clicking on the "Apply" button.
Note: NComputing L-series access devices use remote USB 1.1 or 2.0 to provide transparent USB redirection.
Transfer speeds are subject to protocol & network limitations and these USB devices may require driver
software that is network & multiuser aware; please test peripherals before deploying.
Software Settings (LAN)
The "Software Settings (LAN)" tree allows you to see and change settings for the host PC and all other PCs on
the network that are running the vSpace software. Once you select a server in the tree, the same settings are
present as are in the "Software Settings (local)" tree item.