Nikon LS4000 User Manual
Page 122
112
2
To prevent the film from curling, hold it lightly by both edges, with the emulsion
surface down (shiny surface up), and insert the film as shown below. When the
film has been inserted a short distance, the adapter feed mechanism will activate
and load the film the rest of the way into the adapter.
Inserting Film
Once the film feed mechanism has been activated, do not attempt to remove the film by hand or
otherwise interfere with the feed operation. Failure to observe this precaution could cause an
error.
Keep the film free from dust during insertion and scanning, when the film may be partially ejected
from the scanner.
The status LED will blink while the scanner readies the film for scanning. The status LED
will stop blinking when the scanner is ready to begin scanning.
3
Scan the film as described on pages 86–98 of this manual. For information on
selecting the frame to be scanned, see the following pages.