Nikon LS4000 User Manual
Page 20
En
10
If you will be using the interface board
with devices that require power to be sup-
plied by the computer, you will need to
connect the board to the computer’s
power supply. You will not need to con-
nect the power supply if you will only be
using the 4000 ED, which receives power
from an external source.
Installing the Interface Board (4000 ED Only)
Installing the IEEE 1394/Firewire Interface Board in a PCI Slot
After turning the computer off and disconnecting all cables, insert the interface board in one of
the computer’s PCI slots as shown below. For information on the location of the PCI slots and
on installing PCI boards, see the documentation provided with your computer.
WARNING
Observe caution when installing the interface board. Use of excessive force could damage the
computer or interface board.