NEC GT1150 - Manual (Page 33)

E – 25
Connecting Your PC Or Macintosh Computer
Connecting your PC or Macintosh computer to GT1150 Projector will enable you to project your computer's screen
image for an impressive presentation.
To connect to a PC or Macintosh :
1. Turn off the power to your projector and computer.
2. Use the supplied RGB signal cable to connect your PC or Macintosh computer to the projector.
3. Turn on the projector and the computer.
4. If the projector goes blank after a period of inactivity, it may be caused by a screen saver installed on the
computer.
DVI L/MONO
L/MONO
RGB 2
RGB 1
VIDEO 1
VIDEO 2
S-VIDEO AUDIO OUT
R/Cr G/Y B/Cb
V H/HV
MONITOR OUT
R
L/MONO R L/MONO R
L/MONO R L/MONO R
R
RGB signal cable
(supplied)
RGB signal cable
(supplied)
PC Macintosh
NOTE: To mini D-Sub 15-pin connector on the projector. It is recommended that you use a commercially available distribu-
tion amplifier if connecting a signal cable longer than the supplied one.
For older Macintosh, use a commercially available pin
adapter to connect to your Mac's video port.
Pin adapter for Macintosh
(not supplied)