NEC GT1150 - Manual (Page 36)

E – 28
REMOTE 1
PC CONTROL REMOTE
2
SC, TRIGGER
OUT OUT
IN IN
RGB 2
RGB 1
VIDEO 1
VIDEO 2
S VIDEO AUDIO OUT
R/Cr G/Y B/Cb
V H/HV
MONITOR OUT
L/MONO R L/MONO R
L/MONO R L/MONO R
When Used with One Switcher (ISS-6020/ISS-6020G)
Up to 10 input signals can be accepted when the projector is connected to one Switcher. Using the projector with
the Switcher allows easy adjustment and signal selection.
ISS-6020
Personal computer
VCR
To REMOTE1
To RGBHV output
Optional control cable 15p-15p
(CTL-6010)
To audio input
Audio system
• Select [Advanced Menu] → [Projector Options] → [Switcher Control] → [SW1 Level]. See page E-49 for the information in detail.
• For more information on the Switcher, refer to the user’s manual accompanying the ISS-6020/ISS-6020G Switcher.
• All cables mentioned above are sold separately.
• The RGB2 terminal will not work with the Switcher Control function.
To use the projector with the Switcher ISS-6020 in the Switcher Control mode,
* When connecting with the VIDEO INPUT MODULE (6020-VID), set the VIDEO MODE select switch (S3001) to "8". The VIDEO MODE select
switch is located on the VIDEO INPUT MODULE (6020-VID).
NOTE: While in the Switcher Control mode, a video standard is selected at the projector.
* If you set the VIDEO MODE select switch (S3001) to "8" with the QUAD DECODER installed in the Switcher ISS-6020, the image will not be
displayed correctly.
In that case, first remove the QUAD DECODER from the Switcher ISS-6020.
For more details, contact your dealer.
VCR
Personal computer
To audio output
To slot
BNC ן5 coaxial cable