NEC GT1150 - Manual (Page 40)

E – 32
When used in stand alone operation.
Pin No.
14
5
10
3
4,8,12,11
SHORT/OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
FUNCTION
External control mode ON
External control mode OFF
POWER ON
POWER OFF
PICTURE MUTE ON
PICTURE MUTE OFF
MUTE SOUND ON
MUTE SOUND OFF
* When the combinations other than specified in the above table are selected, the input will be forcefully
switched to RGB 1.
* The term “SHORT” means to connect with pin 15
* When in the external control mode, the POWER, Source/Alphanumeric, PICTURE MUTE and SOUND MUTE
buttons on the remote control will not function.
* When the External control mode is set to ON, the following settings are not effective: Timer, Auto Start, Power
Management, Power Confirmation, Default Source Select.
NOTE: Pin 13 is the external remote signal terminal. The projector can be controlled by the same format signal as the
supplied remote control from the external controller regardless of setting on Pin 14.
NOTE: When turning off the power to the projector using the external control, do not disconnect the plug from the power
outlet. These procedures are to protect your projector and the connected equipment.
11pin
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
SHORT
SHORT
SHORT
SHORT
SHORT
SHORT
12pin
OPEN
OPEN
OPEN
SHORT
SHORT
SHORT
OPEN
OPEN
OPEN
OPEN
SHORT
SHORT
8pin
OPEN
OPEN
SHORT
OPEN
SHORT
SHORT
OPEN
OPEN
SHORT
SHORT
OPEN
OPEN
4pin
OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
RGB 1
VIDEO 1
S-VIDEO
RGB 2
VIDEO 2
RGB1 (S-VIDEO)
DVI (DIGITAL)
PC CARD VIEWER
DVI (ANALOG)
RGB 1 (VIDEO)
RGB 2 (S-VIDEO)
RGB 2 (VIDEO)