NEC GT1150 - Manual (Page 56)

E – 48
[Page 4]
Signal Select (RGB connector):
Allows you to choose "VIDEO" or "S-VIDEO" for RGB 1 or 2 con-
nector.
Normally select "Auto".
[Page 3]
Auto Adjust (RGB Only):
When "Auto Adjust" is set to "On", the projector automatically de-
termines the best resolution for the current RGB input signal to
project an image using NEC's Advanced AccuBlend Intelligent Pixel
Blending Technology.
The image can be automatically adjusted for position and stability;
"Horizontal Position", "Vertical Position", "Clock", "Phase", and
"Resolution."
On ................ Automatically adjusts image display functions ("Video Filter",
"Horizontal Position", "Vertical Position", "Clock", "Phase" and
"Resolution".)
Off ................ User can adjust the image display functions ("Video Filter",
"Horizontal Position", "Vertical Position", "Clock", "Phase" and
"Resolution") manually.
NOTE: The projector has a feature that enters a signal automatically in the Entry
List once you made any adjustments. However, this feature is not available if
you adjust a signal using the Auto Adjust feature. To register the signal after
you use the Auto Adjust feature, first you need to make any one adjustment
manually.
Auto Start:
Turns the projector on automatically when the power cable is in-
serted into an active power outlet. This eliminates the need to al-
ways use the "Power" button on the remote control or projector cabi-
net.
Power Management:
When this option is on and there is no RGB input for five minutes or
more, the projector will automatically turn itself off.
Power Off Confirmation:
This option determines whether a confirmation dialog for turning off
the projector will appear or not.
Keystone Save:
This option enables you to save your current keystone settings.
Saving your change once affects all sources. The changes are saved
when you turn off the projector.
Fan High Speed Mode:
This option allows you to select two modes for fan speed: high-
speed mode and normal speed mode.
When you wish to cool down the temperature inside the projector
quickly, check this box. This is convenient especially when the pro-
jector is installed on the ceiling.
Built-in Speaker:
This option allows you to activate the built-in speakers when you
connect an audio cable to the AUDIO OUT terminal.
Clear Lamp Hour Meter:
Resets the lamp clock back to zero. Pressing this button appears a
confirmation dialog box. To reset the lamp usage hour, press "OK".
NOTE: The projector will turn off and go into standby mode after 1600 hours
(up to 2100 hours in Eco mode) of service. If this happens, press the "Help"
button on the remote control for ten seconds to reset the lamp clock back
to zero. Do this only after replacing the lamp.
Clear Filter Usage:
Resets the filter usage back to zero. Pressing this button appears a
confirmation dialog box. To reset the filter usage hour, press "OK".