NEC GT1150 - Manual (Page 48)

E – 40
Menu Descriptions & Functions
Source Select
When Switcher Control is set to "Standalone", you can select a video
source such as a VCR, DVD player, laser disc player, computer, or
document camera depending on what is connected to your inputs, or
PC Card Viewer (PC card installed).
Enables you to select a video source such as a VCR, DVD player, laser
disc player, computer or document camera depending on what is con-
nected to your inputs.
Press the up/down buttons on your remote control or the projector cabi-
net to highlight the menu for the item you want to project.
* RGB1,2
* Video 1,2
* S-Video
* RGB Digital
* RGB Analog * PC Card Viewer
* RGB1 (VIDEO)
* RGB1 (S-VIDEO)
* RGB2 (S-VIDEO)
* RGB2 (VIDEO)
Entry List
Displays the list of the entry signals. Use the ▲▼ buttons on your re-
mote control or the projector cabinet to select the signal and press the
ENTER button on the remote control or the projector cabinet to project
the image of the selected source.
Entry Edit Command (Expert mode only)
You can edit the signal on the entry list.
To do so:
1. While pressing and holding CTL, press ENTER on the remote control to
display the Entry Edit Command window.
* Cut Enables you to remove a selected signal from the list and place
it on the “clipboard” in the projector.
* Copy Enables you to copy a selected signal from the list and place
it on the “clipboard” in the projector.
* Paste Enables you to paste the signal placed on the “clip-board” to
any other line of the list. To do this, select “Paste” and then select the
line number you want to paste to. Last press ENTER.
* Edit Enables you to change source name or assign the direct key.
* The following buttons are not available for the currently projecting
signals:
1) The Cut and Paste buttons on the Entry Edit Command screen
2) The Input Terminal button on the Entry Edit screen
When complete, select OK and press ENTER. To exit without storing
setting, select Cancel.
Switcher
You can select the slot number from 1 to 10 of the Switcher(s) ISS-
6020.
When using with a single Switcher ISS-6020:
Use the Select ▲ or ▼ button to select the desired slot number from 1
to 10 of the ISS-6020 Swicher and press ENTER.
When using with two or more Switcher ISS-6020:
Use the Select ▲ or ▼ button to select the master slot number from 1
to 10 and then the slave slot number from 1 to 10 on the Select Slot
menu. Select OK and press ENTER.
To close the window without storing the settings, select Cancel and
press ENTER.