NEC Sever Switch Unit N8191-09 - Manual (Page 14)

Power Supply and Power Cord Use
CAUTION
Plug in to a proper power source.
Use a proper wall of specified voltage and current. Use of an improper power
source may cause a fire or a power leak.
Do not install the server switch unit where you need an extension cord. Use of a
cord that does not meet the power specifications of the server switch unit may heat
up the cord and cause a fire.
Do not connect the power cord to an outlet that has an illegal number of
connections.
The electric current exceeding the rated flow overheats the outlet, which may cause
a fire.
Do not connect the power cord to an outlet that has an illegal number of
onnections. c
The electric current exceeding the rated flow overheats the outlet, which may cause
a fire.
Plug the AC cord into the outlet as far as it goes.
Heat generation resulting from a halfway inserted AC cord (imperfect contact) may
cause a fire. Heat will also be generated if condensation is formed on dusty blades
of the halfway inserted plug, increasing the possibility of fire.
Use the authorized AC cord only.
Use only the proper AC cord that comes with the server switch unit. Use of an
unauthorized AC cord may cause a fire when the electric current exceeds the rated
flow. AC cord for Japan (100 VAC) is provided with the server switch unit. Do not
use the provided AC cord in any other country than Japan.
Also, observe the following to prevent an electric shock or fire caused by a
damaged AC cord.
n Do not stretch the cord harness.
n Do not pinch the power cord.
n Do not bend the power cord.
n Keep chemicals away from the AC cord.
n Do not twist the power cord.
n Do not place any object on the AC cord.
n Do not bundle power cords.
n Do not alter, modify, or repair the AC cord.
n Do not use any damaged power cord. (Replace a damaged AC cord with a new
one of the same specifications. Ask your service representative for replacement.)
- viii -