NEC Sever Switch Unit N8191-09 - Manual (Page 92)

2) When the server switch unit enters the hot key mode by pressing the Ctrl key twice:
If you press the Ctrl key twice quickly to enter the server switch unit into the hot key mode,
the OSD display appears at the upper left corner of the screen.
a) Description of screen
1. The status of the server switch unit appears by the OSD display at the upper left corner of the
screen.
2. Before the switching, the character background is displayed red.
3. After the switching, the character background is displayed blue, the connection is completed,
and the operation is terminated in the hot key mode. After about three seconds, the OSD
display disappears.
b) Server switching procedure
The screen display may be switched to another by pressing the numeric key of the desired
server when the background of characters is displayed red.
You can switch a server to another by pressing the proper one of the 1 to 8 keys. In the
cascade connection, select the master side by pressing the proper one of the 1 to 8 keys and
the slave side by pressing the appropriate one of the F1 to F8 keys.
The key operation enables the screen display to be switched from one to another directly.
The proper switching allows the server switch unit to exit from the hot key mode.
If the character background is displayed red, you cannot provide any key entry or mouse
operation for the server.
To change the screen display to that with blue character background (or to terminate the hot
key mode), press the proper number, Esc, or Enter key.
If you press the 0 (zero) key on the screen with red character background, the mode of the
server switch unit is changed to the auto scan mode. The auto scan mode is terminated by
either of the following methods:
Press the Auto Scan switch or the Enter key. Then the screen is switched to that displayed
currently.
Press the Esc key. Then the server selected at the start of the auto scanning is selected.
Tips
For the on-screen display, non-interlace video signals are recommended.
(However, interlace signals having resolution of 1152Ч864, 1280Ч1024, or
1600×1200 can be displayed on the screen properly. Interlaced signals of
lower resolution may extend outside the visible screen.)
Notice
The Auto Scan and Hot Key are disabled during server startup. If you
erroneously pressed the Auto Scan key, cancel the Auto Scan mode, and
select all servers with Server Selection key to check if the startup processes
are in normal progress. If you execute the hot key operation, press the Reset
switch of the server switch unit to restart the server switch unit.
- 63 -