Roland RG-3M - Manual (Page 108)

106
Chapter 7. Connecting External Devices
2. Switch off the power to the RG-3M and the
device you’re about to connect.
3. Use a MIDI cable (sold separately) to connect the
MIDI connectors to each other.
Please refer to the connection examples below.
4. Switch on the power to the RG-3M and the
connected device.
5. Adjust the volume level on the RG-3M and the
connected device.
6. You should also set the MIDI settings as needed.
For details on the MIDI-related settings, refer to next
section.
■ Connection Examples
fig.07-090
* When the RG-3M is connected to a MIDI sequencer, set it to
Local OFF. Refer to “Disconnecting the Internal Sound
Generator and Keyboard (Local Control)” (p. 107).
In addition, turn the MIDI sequencer’s Thru function ON.
The sequencer takes the performance data received at the MIDI
IN connector and outputs the data unchanged from the MIDI
OUT connector.
To determine whether or not your sequencer features a MIDI
Thru function and for instructions on making the Thru
function setting, refer to the owner’s manual for your
sequencer.
fig.07-100
Making MIDI-related Settings
Here’s how you can set the transmit channel and other MIDI
related settings.
■ MIDI Transmit Channel Settings
MIDI features sixteen MIDI channels, numbered 1–16.
Simply connecting a cable is not enough for communication
to take place. The connected devices must be set to use the
same MIDI channels. Otherwise, no sound will be produced,
and no sounds can be selected.
The RG-3M receives all channels 1–16.
1. Press the [Function] (Exit) button, getting its
indicator to light.
2. Press the [Song] (Select -) button or [ ] (Select
+) button to display the MIDI screen.
fig.07-110d
3. Press the [Song] (Select -) button or [ ] (Select
+) button to get the value for “Tx Ch” (Transmit
channel) to flash.
fig.07-120d
4. Press the [ ] (Value -) button or [ ] (Value
+) button to set the MIDI Transmit channel.
Value: 1–16
5. Press the [Function] (Exit) button so the indicator
goes out.
Setup with a MIDI Sequencer
Connecting with a MIDI Sound Module
Jack Panel
In Out MIDI
Roland MT Series
IN OUT
Jack Panel MIDI Sound Module
OUT THRU IN
MIDI
IN
RG-3M_e3.book 106 ページ ２００８年３月２５日 火曜日 午前１０時１分